Smart Power Controller

The smart power controller is connected between the mains supply and the light source. It switches on the supply to the light source when the exposure is started, and switches it off again when the exposure is completed (or paused).

The controller is connected to your mains electric supply using a standard C13 cable (not included) and to your light source using a standard C14 cable (also not included). Please check the online manual for more information.

This device is rated for a 10A load, which is suitable for most installations. (The older 5A “standard” version is no longer available.) If your light unit draws more than 10 amps, especially if it is an LED system, please read the following article: Smart Power Controllers and LED Light Systems.

What’s in the box:

• Power Controller
• Control Cable (connects to the light integrator)

This device requires an LC5, LC4 or LC3 light integrator. If using an LC3 then it must be upgraded to the LC3+ firmware.